© 2012 G Force Automatic Gates All Rights Reserved
Standard Push Button
Wiring Instructions DC 2
Circuit Board
DIY Automatic Gate Kits
Solar & Low Voltage
Specialists
PH 1800 111 930
Undo the 4 screws and
take off the cover
Attach the wire to the terminals on the
push button. We suggest to use
0.75mm figure 8 wire for the push
button wire.
Drill a small hole either at the rear of the
enclosure or the bottom of the enclosure
to run the wire through. Mount the
enclosure to the post. As an option, the
holes can be sealed with silicon. Screw
the cover back on
.
Feed the push button wire
through the hole in the
support tray and connect to
terminals “OSC” and “COM”
Mounting
Screws
Push Button
Wire
