© 2012 G Force Automatic Gates All Rights Reserved
Setting Motor Direction
Refer to the
“DC2 Circuit Board”
data sheet included with this manual and locate the direction
LED’s on the circuit board. The GREEN LED indicates opening direction and the RED LED
indicates closing direction.
Opening Direction
Green LED is on
Closing Direction
Red LED is on
Battery Wires
M1 Motor Terminals.
Red and Black Wires
.
© 2012 G Force Automatic Gates All Rights Reserved
Care should be taken as there are moving components inside the gate motor that may
cause damage or personal injury.
Pre Installation Set Up and
Testing
AG5 DC2 Gate Motor
Activate the gate motor again using the handset remote and check the rotation of the drive
gear is turning in the correct direction for opening the gate and the GREEN LED light is on
OR closing the gate and the RED LED light is on.
Activate the gate motor using the handset remote and check the rotation of the motor drive arm
is turning in the correct direction for opening the gate and the GREEN LED light is on OR the
correct direction for closing the gate and the RED LED light is on.
If the motor is going in the wrong direction, disconnect all power. Refer to the “
DC2 Circuit Board”
data sheet included with this manual and locate the ‘M1 Motor’ terminals on the circuit board.
Swap the red and black motor wires connected to ‘M1 Motor terminals on the circuit board. The
red wire should be connected to the terminal that had the black wire connected to it and the
black wire should be connected to the terminal that had the red wire connected to it. This will
reverse the direction of the motor.
ALWAYS TURN THE POWER OFF AND DISCONNECT THE BATTERY BEFORE MAKING
ANY WIRING CONNECTIONS
