FUTABA FDL01TU, Instruction Manual

Page: 65 / 83

51
This command enables serial data output after it has been disabled with the
ODA
command .
When the modem’s power is turned on (or a reset), the modem is in the state to
enable
the
received data output
.
Example
>
@
ODA
CR/LF
:
disable
serial output of received wireless data
<P0
CR/LF
: command accepted
(Data is not output during this period even if received.)
>
@
OEN
CR/LF
:
enable
serial output of received wireless data.
<P0
CR/LF
: command accepted
<RXT002HELLO
CR/LF
: outputs data stored in receive buffer
<RXT003MAIL
CR/LF
: and any new data received
PAS Reference and Set Repeater Address
Syntax
PAS (:Repeater Address1 :Repeater Address2)
Repeater Address : repeater address to pass through
Response
xxx : xxx : current address (reference)
P0 : command accepted (setting)
N0 : command error
Function
In the
headerless stream mode
, references and sets the
repeater address
to
pass through
When no repeater address is set, the current setting can be referenced.
This command is used to temporarily change repeater address . To change the
default value, change
REG13
.
Example
>
@
PAS
CR/LF
: references the current
repeater address
<004 : A00
CR/LF
: current repeater address is 004
<P0
CR/LF
: command accepted
<
@
PAS:002:A00
CR/LF
: sets the repeater address to 002
<P0
CR/LF
: command accepted
Notes
This command is not allowed to be used in 485 mode .