FUTABA FDL01TU, Instruction Manual

Page: 47 / 83

33
•
Sets the
terminator
to identify the breakpoint of a packet. The modem transmits data
considering this character as the breakpoint of a packet.
•
In case of using an arbitrary terminator, set it to REG16 and 17 .
Bit 1: Source address check
0 Inhibit source address checking (default value)
1 Activate source address checking
Table 5–4: Source Address Check Settings
•
When the source address checking is active and the source address in the
received
packet header
does not match the
destination address setting
(
REG02
),
the data is discarded (data cannot be received).
Bit 0: Destination address check
0 Inhibit destination address checking on receipt (default)
1 Activate destination address checking on receipt
Table 5–5: Destination address check
•
When the destination address checking is active and the destination address in
the received packet header does not match the received modem’s local station
address
(
REG00
), the data is discarded (data cannot be received).
REG19: Communication Setting 2 [default value: 00H]
Bit 7: Reserved
•
The FDL01TU does not use this register. Keep the default value as it is.
Bit 6: Diversity Reception
0 Disable diversity reception (default value)
1 Enable diversity reception
Table 5–6: Diversity Reception Settings
•
Enable/disable diversity reception .
•
To enable diversity reception , set this bit to 1.
•
Enabling
diversity reception
with only one antenna connected may degrade the
reception performance.
Bit 5: Broadcast Transmission Reception
0 Enable broadcast transmission reception (default value)
1 Disable broadcast transmission reception
Table 5–7: Broadcast Reception Settings