FUTABA FDL01TU, Instruction Manual

Page: 29 / 83

15
The following list shows each command’s syntax as issued at the sender terminal
equipment and the response displayed at the receiver terminal equipment when the packet is
received.
1. Direct Text Data Transmission
transmit:
@
TXT [destination address]{source address}[message]
receive: RXT [source address][message]
CR/LF
2. Direct Binary Data Transmission
transmit:
@TBN[destination address]{source address}[message length][message]
CR/LF
receive: RBN [source address][message length][message]
CR/LF
3. Text Data Transmission through Repeater
transmit:
@TXR [repeater address][destination address]{source address} [message]
CR/LF
receive: RXR [repeater address][source address][message]
CR/LF
4. Binary Data Transmission through Repeater
transmit:
@
TBR [repeater address][destination address]{source address}
[message length][message]
CR/LF
receive: RBR [repeater address][source address][message length][message]
CR/LF
where {source address} is optional, used in
RS485 mode set by serial communication
cable 12 pin.
The following list defines the parameters and symbols used in the commands above:
@
= command header
CR/LF
= carriage line feed
destination address = address of modem to receive the message (000 to 239)
source address = address of modem sent the message (000 to 239)
repeater address = address of the repeater modem (000 to 239)
message length = number of bytes in message
message = information data (255 bytes or less)
In the
text data transmission
, the message is considered to be
terminated when the CR/LF code appears in it. No data after that will
be transmitted. When the CR/LF code contains in a message, use the
binary data transmission
command.
CAUTION