FUTABA FDL01TU, Instruction Manual

Page: 58 / 83

44
6.1
Command Set Description
This section provides a description of each command available in the FDL command set.
The table below lists each command and it applicability in each operation mode.
Command Function
1 ARG Reference All Memory Resisters
2 BCL
Clear Transmit and Receive Buffers
3 CON Connect Wireless Link
4 DAS Reference and Set the Destination Address
5 DBM Read Signal Strength
6 DCN Disconnect Wireless Link
7 FRQ Reference and Set Frequency Group
8 INI Initialize All Memory Resisters
9 ODA Disable Received Data Output
10 OEN Enable Received Data Output
11 PAS Reference and Set Repeater Address
12 RDA Disable Wireless Reception
13 REG Reference and Set Memory Resisters
14 REN Enable Wireless Reception
15 RID Display Received Serial ID
16 RNO Reference and Set Retransmission Count
17 ROF RF Circuit Block Power Down
18 RON RF Circuit Block Power Up
19 RST Reset
20 SAS Reference and Set Local Station Address
21 STS Read Status
22 TBN Transmit Binary Data
23 TBR Transmit Binary Data Through Repeater
24 TID Display Local Station Serial ID
25 TXR Transmit Text Data Through Repeater
26 TXT Transmit Text Data
27 VER Reference Version Information
Table 6–1: Command to Mode Availability
The symbols used in this section have the following meaning:
> : Input character from the terminal equipment to the modem
< : Output from the modem to the terminal equipment
@
:
Command header
CR/LF
: Terminator (carriage line feed)
[ ] : Required input parameter/s Be sure to input.
( ) : Optional input parameter/s May be omitted
{} :
485 mode local station address
(
REG00
). Be sure to
input at 485 mode
In the Syntax and Response segments of the following command descriptions the
terminator
symbol (
CR/LF
) has been omitted for clarity.