Furuno RC-1500-1T, Operator'S Manual

Page: 404 / 418

A-14
Message file is too big (partial transmission possible).
The size of the file you want to send is
larger than 31,500 bytes. (The file can be
sent, but only the first 32,000 bytes of in-
formation will be received.)
Message is entered in sending buffer.
Before a message is transmitted it is sent
to the message queue. This alert informs
you the message has been accepted by the
message queue.
Message Send failed. Could no send message because of satel-
lite malfunction, etc.
Message Send pending
.All circuits occupied at LES.
Message Send rejected. This alert appears when the LES rejects a
message because of unpaid subscriber’s
fee or other reasons.
No response from communication unit!
This message will appear if the communi-
cation unit is turned off or its interconnec-
tion cable is disconnected or damaged.
Now Self-testing Terminal. (cannot abort)
Appears during testing of terminal unit.
Now printing
Appears during printing.
Now Formatting Appears during formatting of floppy disk.
OK to delete file? This alert verifies if it is alright to delete a
file.
OK to format FD?
This alert verifies if it is alright to format
a floppy disk.
Printer error!!
The printer is off or malfunctioning.
Request started
This message appears when requesting
delivery status of a message.
SAVING You will see this message when saving a
file.
SES is not idle now. Cannot start PV Test.
This message means you will have to wait
until the communication unit is idle to start
the PV test.
Starting Scan Process Press any key to escape.
This prompt appears before scanning NCS.
Update error! Retry again. Press RET to update end.
This message appears if the distress alert
message was updated incorrectly.