Furuno FAR-3230SW-BB, Installation Manual

Page: 48 / 169

2. WIRING
2-12
does not extend past the flat washers, then pass the antenna cable through the
cable entrance.
5. Pass the serial cable through the locking wire saddle circled below. Attach the ca-
ble to appropriate WAGO connectors, referring to the interconnection diagram,
then connect them to the RF-TB Board.
-
TB802 (motor) : 8 pin
- TB803 (signal) : 16 pin
- Ground wire : Attach crimp-on lug (FV1.25-3(LF) RED) to wire. Fasten the
crimp-on lug to the chassis with the screw shown below.
6. Apply sealant 1211 (supplied as installation material) to the threads of the clamp-
ing gland, and then fasten it tightly with the hook spanner wrench.
Note: Use the wrench of the correct size. If you do not have the hook spanner
wrench, contact your dealer.
Sheath Sheath
Cable gland
Cable gland
Flat washer
Flat washer
Gasket
Gasket
Flat washer
Flat washer
Trim the armor.
Push the flat washer
against the armor.
Outer sheath
Outer sheath
Inner sheath
Inner sheath
TB802
TB803
Locking wire saddle
for serial cable Locking wire saddle
for serial cable
Fasten ground
wire of serial cable
with this screw. Fasten ground
wire of serial cable
with this screw.