Furuno FAR-3230SW-BB, Installation Manual

Page: 43 / 169

2. WIRING
2-7
4. Unfasten the four screws fixing the cable clamp plates (2 pcs.).
5. Pass the serial cable (TTYCYSLA-10) through the cable entrance and the locking
wire saddle circled below. Attach appropriate WAGO connectors (TB802, 8 pin;
TB803, 16 pin, 10 pins used) to the serial cable and attach the connectors to the
RF-TB board. Attach the crimp-on lug (preattached to chassis) shown below to the
drain wire and connect the wire to the chassis.
Cable slot for serial cable
Cable slot for de-icer
Cable entrance
Cable clamp plate
for serial cable
Cable clamp plate for de-icer
DUMMY PLUG
Dummy plugs are provided to
insert into the unused cable slots.
Insert the plugs for waterproofing.
Note : A terminal opener is provided on the
RF-TB Board.
Locking wire saddle
TB803
TB802
Attach crimp-on lug (pre-attached to
chassis) to drain wire and connect
to chassis.
How to connect wires to WAGO connector
Press downward.
Terminal opener
WAGO connector
Wire
Twist
<Procedure>
1. Twist the cores.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.