Furuno FAR-3230SW-BB, Installation Manual

Page: 58 / 169

2. WIRING
2-22
• The transceiver unit output flange is a plain type and the antenna unit output flange
is a choke type, and it is important to maintain this relationship throughout the
waveguide run.
• After installation of the waveguide is completed, the coupling portions must be
sealed by using the adhesive supplied.
• In a very short time the surface of the waveguide becomes green with verdigris.
Therefore, paint both the surface of the waveguide and flanges to avoid corrosion
and water penetration. Paint must not be allowed to reach the inner surface of the
waveguide or the mating surface of any flange.
2.3.3 Transceiver unit for FAR-3330SW
Antenna cable, serial cable, sub monitor
1. Remove the cover of the unit.
2. Unfasten the bolts from the cable clamp. Lay the cables in their cable slots so their
armors rest in the slots.
3. Connect the power line of the antenna cable, serial cable and sub monitor to the
RF-TB Board as shown in the figure below and on the next page.
• Antenna cable (power): TB801
• Serial cable: TB802, TB803
• Sub monitor cable (power): TB803
• Sub monitor cable (coaxial): TB804
Thru-deck hole
Weld here.
Deck
TRANSCEIVER
UNIT
Drain waveguide
Watertight film
Cable entrance
S
u
b
m
o
n
it
o
r
c
a
b
le
Sub monitor cable A
n
te
n
n
a
c
a
b
le
Antenna cable S
e
ri
a
l
c
a
b
le
Serial cable