Furuno FAR-3230SW-BB, Installation Manual

Page: 50 / 169

2. WIRING
2-14
11. DE-ICER INSTALLATION . Follow all steps if the de-icer is not already installed.
(See also “X-band De-icer Kit Installation Instructions”, issued separately.) If the
de-icer is already installed, do only steps 1) through 7). If the de-icer is not provid-
ed, go to step 12.
1) Unfasten the clamping gland for the de-icer’s power cable, then remove the
gasket, flat washers and cover.
2) Slide the clamping gland, flat washer, gasket and flat washers in that order
onto the cable as shown in step 4 on page 2-11.
3) Unfasten two bolts to remove the RF-TB assembly, then pass the power cable
for the de-icer through the cable entrance.
4) Set the supplied locking wire saddle at location (5) in the figure below. Pass
the cable through locking wire saddles (1) to (5).
DE-ICER Board (03P9573)
Voltage Selection switch
[TEST] button [TEST] button
TB901 TB901
Cable entrance Cable entrance
TB assembly TB assembly