Furuno CSH-23, Installation Manual

Page: 21 / 98

16
Clamping the cable
Clamp the cable where the shield is folded back onto the armor.
Figure 4-6 Clamping the cable
Assembling connector NSC-253P (CN-A15)
Figure 4-7 Assembling connector NSC-253P
Assembling BNC connector
(CN-A7, CN-A8, CN-A9, CN-A10, CN-A11 and
CN-A12)
1. Remove vinyl sheath of the cable by 15 mm.
2. Pass the cable through the nut, washer, gasket and clamp.
3. Unravel the shield and fold it back onto the clamp.
4. Remove the insulator, leaving 3 mm.
5. Trim the shield as shown in the drawing. Solder the center chip to
the conductor of the cable.
6. Pass the cable through the housing and tighten the nut.
Figure 4-8 Assembling BNC connector
Cable DPYCY-1.5
1.5
1.5
1.56