Fukuda Denshi HS-8000 Series, Service Manual

Page: 98 / 132

9
－
2
DIP Switch Setup
In this section, the settings of the DIP switch are explained.
HS-8000 DIP Switch Setup
Dip switches are located at the bottom under the maintenance cover of the Super Unit.
SW No. Default Description (When ON)
1 OFF Initialize internal setup to factory default setup.
2 OFF Release the boot area protect of flash memory.
3 OFF
Use only for factory adjustment and periodical check (Memory
test mode)
4 OFF Not used (Reserved function)
5 OFF
Use only for factory adjustment and periodical check (for
measurement such as frequency characteristic)
6 OFF
Use only for factory adjustment and periodical check (NIBP test
mode)
7 OFF Use only for factory adjustment (AUX debug mode)
8 OFF Force Installation, EEPROM Installation
1
：
When the power is turned ON with this mode, the user settings will be initialized.
2
：
Set up only when installing the software (upgrading boot program).
5
：
Set this function OFF for ordinary use since this function is used for factory inspection and
periodical check.
6
：
Set this function OFF for ordinary use since this function is used for factory inspection and
periodical check.
7
：
Set this function OFF for ordinary use since this function is used for factory inspection.
8
：
Set up only when installing the software (upgrading boot program).
Prevents unintended installing. Normally the setting is OFF.
C A U T I O N
Return the cover to its original position after changing the setting to prevent
users from changing the setting easily.