Fujitsu SPARC M10-1, Service Manual

Page: 142 / 230

Caution -
Do not attempt to insert an internal disk into a slot when the lever is closed.
Otherwise, the internal disk could jam and prove difficult to remove.
Note - When expanding an internal disk, remove the filler unit of the internal disk from the
slot into which you will install the internal disk.
Note - Do not force the internal disk into the slot. Using excessive force may damage the
component or the chassis.
11.5 Installing an Internal Disk
This section describes the procedure for installing an internal disk. Perform
expansion using the same procedure.
1.
Open the lever and hold the internal disk.
2.
Carefully insert the internal disk into the slot.
3.
Close the lever to secure the internal disk.
11.6 Restoring the System
This section describes the procedures for restoring the system after replacement,
expansion, and reduction of internal disks. The restoration procedure differs
depending on the maintenance type as follows:
■
Active/hot maintenance
■
Inactive/hot maintenance (system stopped/hot maintenance)
■
Inactive/cold maintenance (system stopped/cold maintenance)
11.6.1 Active/hot maintenance
The procedure may vary depending on the configuration of the internal disk.
When the system is configured with a hardware RAID
The operation varies depending on the hardware RAID configuration (RAID 0, RAID
1, or RAID 1E). For details, see "14.2.10 Replacing a failed disk drive" in the Fujitsu
M10/SPARC M10 Systems System Operation and Administration Guide .
Fujitsu M10-1/SPARC M10-1 Service Manual
･
November 2014 126