Fujitsu SPARC M10-1, Service Manual

Page: 110 / 230

Note - In the case of a dual power feed, connect the power cords in their original positions by
referring to the record that you made before the start of maintenance.
XSCF>
testsb -a
8.6.2 Restoring the chassis
1.
Install the air duct and the PSU backplane cover.
For details, see " 6.3.2 Installing the air duct and PSU backplane cover ."
2.
Install the upper cover.
For details, see " 6.3.3 Installing the upper cover ."
3.
Close the fan cover.
For details, see " 6.3.4 Closing the fan cover ."
4.
Put the chassis into the rack.
For details, see " 6.3.5 Putting the chassis into the rack ."
5.
Connect all the power cords to the power supply unit.
For details, see " 6.3.6 Installing the power cords ."
8.7 Restoring the System
This section describes the procedure for restoring the system after replacement,
expansion, and reduction of memory.
1.
Check that the XSCF STANDBY LED on the operation panel is on.
2.
Switch the mode switch on the operation panel to Locked mode.
For details, see " 2.2.2 Control function of the operation panel ."
3.
Log in to the XSCF shell.
4.
Execute the testsb command to confirm that the memory requiring maintenance
is recognized normally.
5.
Start the system.
For details, see " 6.2 Starting the System ."
6.
Close the rack door.
Fujitsu M10-1/SPARC M10-1 Service Manual
･
November 2014 94