Fujitsu SPARC M10-1, Service Manual

Page: 99 / 230

XSCF>
version -c xcp -v
BB#00-XSCF#0 (Master)
XCP0 (Current): 2011
CMU : 02.01.0001
(*1)
POST : 1.20.0
OpenBoot PROM : 4.34.0+1.2.0
Hypervisor : 0.21.11
XSCF : 02.01.0001
XCP1 (Reserve): 2011
CMU : 02.00.0006
(*2)
POST : 1.13.0
OpenBoot PROM : 4.34.0+1.0.5
Hypervisor : 0.21.3
XSCF : 02.01.0001
CMU BACKUP
#0: 02.01.0001
#1: ..
XSCF>
XSCF>
setdate -s 102016592013.00
When the system is configured with a hardware RAID
1.
Check that the XSCF STANDBY LED on the operation panel is on.
2.
Switch the mode switch on the operation panel to Locked mode.
For details, see " 2.2.2 Control function of the operation panel ."
3.
Log in to the XSCF shell.
4.
Execute the version command to confirm the firmware version information.
If the XCP firmware version does not match that used before the replacement,
update the firmware.
For details, see "16.1.3 Updating firmware" in the Fujitsu M10/SPARC M10
Systems System Operation and Administration Guide .
If you replace the microSD card, the CMU firmware versions do not match.
However, you do not need to perform an update.
The following example shows "02.01.0001" (*1 in the execution example) as the
CMU firmware version of the current XCP, and "02.00.0006" (*2 in the execution
example) as the CMU firmware version of the reserve XCP. Thus, you can see
that the CMU firmware versions do not match.
5.
Execute the setdate command to set the XSCF time.
Specify the time in either of the following formats:
yyyy.MM.DD-hh:mm:ss year.month.day-hour (24-hour clock):minute:second
MMDDhhmmyyyy.ss monthdayhour (24-hour clock) minuteyear.second
In the following example, "October 20, 2013 16:59:00" is specified.
Chapter 7 Maintaining the Motherboard Unit 83