Fujitsu SPARC M10-1, Service Manual

Page: 53 / 230

Note - Before stopping the system, inform the users that the system will be stopped.
Note -
If a physical partition is stopped by executing the XSCF command or through the
operation panel, all the logical domains on the physical partition are stopped. Stop the
application if required.
XSCF> showpparstatus -a
PPAR-ID PPAR Status
00 Powered Off
XSCF> showdomainstatus -p 0
Logical Domain Name Status
primary Solaris powering down
4S-159-D0-G0 Solaris powering down
4S-159-D0-G1 Solaris powering down
4S-159-D0-G2 Solaris powering down
5.2 Stopping the System
This section describes the procedures for stopping the system.
There are two ways of stopping the system, as follows:
■
Stopping the system with an XSCF command
■
Stopping the system from the operation panel
1.
Stop the system.
For details, see " 5.2.1 Stopping the system with an XSCF command " or " 5.2.2
Stopping the system from the operation panel ."
2.
Execute the showpparstatus command to confirm that the power to the
physical partition is turned off.
In the following example, [PPAR Status] of PPAR-ID 00 displays "Powered Off",
which indicates that the power to the physical partition has been turned off.
3.
Execute the showdomainstatus command to confirm the operating condition
of the logical domain.
In the following example, [Status] of the logical domain displays "Solaris
powering down", which indicates that Oracle Solaris is shutting down.
5.2.1 Stopping the system with an XSCF command
1.
Switch the mode switch on the operation panel to Service mode.
For details, see " 2.2.2 Control function of the operation panel ."
2.
Log in to the XSCF shell.
3.
Execute the poweroff command.
Chapter 5 Understanding the Preparations for Enabling Maintenance 37