Fujitsu SPARC ENTERPRISE T1000, Installation Manual, Page: 71 / 84

Appendix A Updating the Server Firmware 45
■ -v
is the flag to turn on verbose message output
5. Reset the system controller.
After the flash has been updated, you must reset the system controller for the new
image to take affect. To reset the system controller, issue the
resetsc
command, as
shown below.
Note – To bypass the confirmation prompt, you can use the
-y
flag with the
resetsc
command. If
resetsc
is issued from a Telnet or SSH session, upon reset
the Telnet or SSH session will be terminated. The output from the reset will be
displayed on the serial console on the system controller.
The system controller resets, runs diagnostics, and returns to the login prompt (on
the serial console), similar to
CODE EXAMPLE A-1
.
sc> flashupdate -s
xxx
.
xxx
.
xx
.
xx
-f
pathname
Username:
username
Password:
password
............................................................... .
Update complete. Reset device to use new image.
sc>
sc> resetsc
Are you sure you want to reset the SC [y/n]? y
User Requested SC Shutdown
CODE EXAMPLE A-1
Typical Boot Sequence Following Firmware Update
ALOM BOOTMON v1.2.0
ALOM Build Release: 000
Reset register: f0000000 EHRS ESRS LLRS SWRS
ALOM POST 1.0
Dual Port Memory Test, PASSED.
TTY External - Internal Loopback Test
TTY External - Internal Loopback Test, PASSED.
TTYC - Internal Loopback Test
TTYC - Internal Loopback Test, PASSED.