Fujitsu SPARC ENTERPRISE T1000, Installation Manual, Page: 70 / 84

44 SPARC Enterprise T1000 Server Installation Guide • April 2007
▼
To Update the Firmware
1. Ensure that the ALOM CMT system controller network management port is
configured.
This is required to access the new flash image over the network. See “To
Configure the System Controller Network Management Port” on page 31 .
2. Open a Telnet or SSH session and connect to the system controller.
The following example is for Telnet.
3. Login as
admin
, using the password you defined during the configuration of
the system controller.
4. Execute the
flashupdate
command.
The
flashupdate
SC command updates the system controller flash image and the
host firmware. The
flashupdate
command requires the following information:
■
IP address of an FTP server on the network that can access the flash image.
■
Full path name to the flash image that the IP address can access.
■
Username and password of an account registered on the system that is specified by the IP
address.
The command usage is as follows:
flashupdate [-s
IPaddr
-f
pathname
] [-v]
where:
■ -s
IPaddr is the IP address of any FTP server on the network that can access the
flash image
■ -f
pathname is the full path name to the flash image
% telnet
xxx
.
xxx
.
xx
.
xx
Trying
xxx
.
xxx
.
xx
.
xx
...
Connected to
xxx
.
xxx
.
xx
.
xx
.
Escape character is’^]’.
Please login:
Please login: admin
Please Enter password:
password
sc>