Fujitsu SCENIC S, Operating Manual

Page: 11 / 69

A26361-K523-Z100-6-7619
3
Important notes
In this chapter you will find information regarding safety which it is essential to take note of when
working with your PC.
Safety
This device complies with the relevant safety regulations for data processing equipment. If you have
any questions, contact your sales outlet.
!
The safety information is contained in the "Safety, Warranty and Ergonomics" manual.
The following outlines some of the most important safety information:
During installation and before operating the device, please observe the instructions on
environmental conditions in the chapter entitled "Technical data" as well as the
instructions in the chapter "Preparation for use and operation".
Please check whether the device is correctly set for the local power supply (see chapter
"Preparation for use and operation").
The power switch and the ON/OFF switch do not disconnect the device from the
electricity supply. To completely disconnect the electricity supply, remove the power plug
from the mains supply.
Replace the lithium battery on the system board in accordance with the instructions in the
chapter "System expansions - Replacing the lithium battery".
Caution: components in the system can get very hot.
Manufacturer’s notes
Keep this Operating Manual together with your device. If you pass on the device to third parties, you
should include this manual.
Energy saving
When the PC is delivered, some energy-saving functions are already set (see the Technical Manual
for the system board or the "BIOS Setup" manual).
·
If you are not using your PC, switch it off.
·
In the BIOS Setup you may set further energy-saving functions for the PC (see the Technical
Manual of the system board or in the manual "BIOS Setup").
Energy saving under Windows NT
If the attached monitor and graphics card support VESA (DPMS) power management the screen
saver
Powersaver ("Drivers & Utilities" CD) can be used to switch the monitor into power
management mode.