Fujitsu Primergy RX4770 M1, Upgrade And Maintenance Manual

Page: 82 / 332

82 Upgrade and Maintenance Manual
RX4770 M1
Basic software procedures
V
CAUTION!
The system is now operational, however, data redundancy will not be
available until the RAID array rebuild is complete. Depending on the hard
disk drive capacity the overall process can take up to several hours, in
some cases even days.
I
You may notice a slight performance impact during rebuild.
5.2.15 Looking up changed MAC / WWN addresses
When replacing a network controller, the MAC (Media Access Control) and
WWN (World Wide Name) addresses will change.
I
In addition to the procedures described below, MAC / WWN addresses
can also be found on the type label attached to a network controller or
system board.
5.2.15.1 Looking up MAC addresses
Ê
Enter the ServerView iRMC web frontend.
Ê
Select the System Information menu.
Ê
Under Network Inventory , you will find detailed information on each network
controller in the managed PRIMERGY server, including its MAC address.
I
This information is only available with the iRMC S4 or above.
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
Ê
Inform the customer about the changed MAC address.
5.2.15.2 Looking up WWN addresses
Emulex FC / FCoE adapters
Ê
Enable the network controller’s Option ROM in the system board BIOS as
described in section
"Enabling Option ROM scan" on page 71 .
Ê
Restart the server.