120
U41147-J-Z156-2-76
Converting a rack model into a floorstand model
Appendix
To convert the server, you will require a Torx-TX20 screwdriver.
Ê
Shut down the operating system, switch off the server, and disconnect it
from the main power supply.
V
CAUTION!
The power switch does not disconnect the device from the line
voltage. To disconnect the line voltage completely, remove the power
plug from the grounded power outlet.
Ê
Remove the server from the rack (see section “Installing the rack model” on
page 26).
Ê
Remove the slot cover (see chapter “Opening and closing the server” on
page 47).
Ê
Remove the front panel (see section “Removing/mounting the front panel”
on page 98).
Ê
Remove the cage for the accessible drives (CD) (see section “Accessible
drives” on page 75).
Ê
Carefully pull out 1/3 of the cage for the hard disk drives from the cage
guides (see also section “Converting 1 to 2-channel version (1.6-inch HD
subsystem)” on page 101).
Ê
Disconnect the data cable for the LCD control panel from the power
backplane (connector X6, accessible between the separator wall and the
PCI slot cover; see figure 60 on page 115).
Figure 65: Removing the cages
2
1
Summary of Contents for PRIMERGY H200
