Fujitsu MAA3182FC Series, Manual

Page: 291 / 327

C141-E054-02EN 5 - 14
Table 5.3 Sense data error classification (2 of 3)
K * C * Q * Outline of Error L *
Recovery Method
(See Table 5.4.)
4 03 xx Peripheral device write fault Need 7
32 01 Defect list update failure
These are errors detected in the operation of the
disk drive.
4 15 xx Positioning error Need 12
This is an error of the disk drive's seek system.
4 32 00 No defect spare location available None 19
No usable alternate blocks exist on the disk
drive.
4 40 nn Diagnostic failure on component 'nn' Need 13
An error was detected in the IDD's self-diagnosis.
4 44 nn Internal target failure Need 20
An internal hardware error or a microcode
detection error was detected in the IDD.
4 4C Ax Microcode list error Need 5
The microcode, etc. recorded on the disk media
cannot be read correctly.
4 4C Ex Calibration failed Need 10
C4 xx Drive failure
The initial seek was terminated abnormally. Or,
a serious error was detected in the drive's control
system.
5 20 00 Invalid command operation code None 2
21 00 Logical block address out of range
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list
There is an error in the command specification
contents.
6 29 xx Power on, reset, or TARGET RESET occurred None 16
6 2A 01 Mode parameters changed None 21
The MODE SELECT parameters were changed
by another INIT.
* K: Sense Key C: Sense Code
Q: Sub-sense code L: Logging Necessary? (shown in Section 5.2.3)