Fujitsu MAA3182FC Series, Manual

Page: 284 / 327

C141-E054-02EN 5 - 7
Table 5.2 Sense and subsense codes (2 of 4)
C * Q * Name Explanation
Sense
key
19 02 Defect list error in
primary list An error was detected during reading of the defect list (P List). 3
03 Defect list error in grown
list An error was detected during reading of the defect list (G List). 3
80 Log information read error An error was detected during reading of statistical information. 3
81 Log information write
error A write error was detected during writing of statistical
information. 3
82 Mode select SA read error An error was detected during reading of SA information
(Mode select parameter).
3
83 Mode select SA write
error An error was detected during writing of SA information (Mode
select parameter). 3
1C 01 Primary defect list not found The defect list (P List) header is incorrect. 3
02 Grown defect list not found The defect list (G List) header is incorrect. 3
90 SA information list not
found The SA information (MODE SELECT parameter) header is
incorrect. 3
1D 00 Miscompare during verify
operation Comparison of data transferred from the INIT by a VERIFY
command (when the Byte Check mode was specified) with
data read from the disk media was terminated unsuccessfully. E
20 00 Invalid command
operation code CDB byte 0 (operation code) is illegal. 5
21 00 Logical block address out
of range A logical block address which exceeds the drive's maximum
value was specified. 5
24 00 Invalid field in CDB There is an error in a specification in the CDB. 5
26 00 Invalid field in parameter
list There is an error in the parameter list specifications transferred
from the INIT during command execution. 5
27 00 Write protected A write operation was attempted in a write protected area. Or
a write operation is prohibited at the external operation panel. 7
29 01 Power on occurred Microcode was downloaded immediately after power on. 6
03 TARGET RESET
message occurred A TARGET RESET was received. 6
2A 01 Mode parameter changed The MODE SELECT parameter values were changed by
another INIT.
6
2F 00 Command cleared by
another INIT A command was forcibly terminated by another INIT during
execution or queuing.
• By a CLEAR TASK.
• The sense hold state was entered when the QErr bit was set
on "1."
• The DQue bit was changed from "0" to "1."
6
31 00 Medium format corrupted The media format is different from the original format. (The
media was not formatted after the data format specification
was changed by the MODE SELECT command.)
3
01 FORMAT command
failed For some reason, formatting cannot be completed and
reformatting is necessary. 3
* C: Sense Code, Q: Sub-sense Code