Fujitsu MAA3182FC Series, Manual

Page: 292 / 327

C141-E054-02EN 5 - 15
Table 5.3 Sense data error classification (3 of 3)
K * C * Q * Outline of Error L *
Recovery Method
(See Table 5.4.)
6 2F 00 Commands cleared by another INIT None 25
Commands were cleared by another INIT.
6 3F 01 Microcode has been changed None 27
6 5B 01 Log exception (Threshold condition met) None 26
The current cumulative value exceeded the
current threshold value.
02 Log count at maximum
The current cumulative value reached the
maximum value.
B 47 00 FC parity error Need 3
B 4E 00 Overlapped commands attempted None 2
Before execution of a command was completed,
a new command was issued by the same INIT.
E 1D 00 Miscompare during verify operation None 24
Data failed to match in the Byte check mode of
the Verify command.
* K: Sense Key C: Sense Code
Q: Sub-sense code L: Logging Necessary? (shown in Section 5.2.3)
Table 5.4 Error recovery processing procedures (1 of 5)
Recovery
Method
Recovery Processing Procedure
0 It is not necessary to perform the error recovery processing. Continue processing.
1 Error recovery processing is impossible. Terminate processing.
2 This is a programming error and error recovery processing is impossible. Terminate
processing and correct the error in the system (INIT) programming.
3 This is an error in the FC protocol and error recovery processing is impossible.
Terminate processing and check the system's FC Loop operation.
4 1) Reissue the original command (Retry).
2) If the command is terminated with the same error when retried, perform recovery
method 3 or 1.
3) If the command is terminated with a different error when retried, execute the
recovery processing procedure for that error.
5 1) After waiting about 1 second, reissue the original command (Retry).
2) If it doesn't recover after 10 retries, perform recovery method 1.