Fujitsu ETERNUS DX S5 Series, Design Manual

Page: 253 / 335

●
Rear View
• ETERNUS DX500 S5
Figure 150 Rear View of a Controller Enclosure (ETERNUS DX500 S5)
8 8
1 1
5 6 4 3
9 9
CPSU#0 CPSU#1
CA#0
CA#1 CA#0
CA#1
2 2
CM#0
CM#1
BUD#1 BUD#0
BUD#1 BUD#0
7
1
Controller (CM#0, CM#1)
(Refer to
"Controllers" (page 257) .)
2
Host interface (CA#0, CA#1)
(Refer to
"■ Host Interfaces" (page 259) .)
3
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 263) .)
4
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 263) .)
5
FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 263) .)
6
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
"■ Drive Interface Ports" (page 263) .)
7
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
"■ PWC Ports" (page 263) .)
8
Power supply unit (CPSU#0, CPSU#1)
(Refer to
"■ Power Supply Units" (page 264) .)
9
BUD (BUD#0, BUD#1)
(Refer to
"■ BUD" (page 258) .)
6. Hardware Configurations
Controller Enclosure
253 Design Guide