Scalar 50 Tape Library
Scalar 50
Quick Start Guide
Introduction
The Scalar 50 tape library is an automated storage and retrieval device
consisting of up to two full height tape drives or four half height tape drives
and up to 32 SDLT cartridges or 38 LTO tape cartridges (see
figure 1
).
This instruction uses the following conventions:
This document explains how to unpack the Scalar 50 tape library and install
it in a standard 19 in. rack. Once the library is unpacked and installed, set
up the library using the instructions in the
Scalar 50
User’s Guide
PN 81-
81768.
This installation procedure will take approximately 4 hours to
complete.
Note:
Notes emphasize important information related to the main
topic.
Caution:
Cautions indicate potential hazards to equipment and are
included to prevent damage to equipment.
Warning:
Warnings indicate potential hazards to personal safety and
are included to prevent injury
.
Note:
It is recommended to review the entire document prior to
beginning the installation.
Contents
0
Introduction..............................................1
Choosing a Location.................................2
Rack Space Requirements .....................2
Environmental Conditions ....................2
Preparing for the Installation..................3
Providing Necessary Tools ....................3
Taking ESD Precautions.........................3
Unpacking the Scalar 50 Tape Library .....4
Installing the Library................................6
Locating the Mounting Position...........6
Installing the Library.............................7
Initial Configuration............................23
Setup Wizard ..........................................31
Multiple Library Stacks ..........................36
Testing the Library Configuration .........39
Enabling Capacity on Demand ..............42
