Installing the Library
17
Scalar 50 Tape Library
2
Remove the restraining bolt from the left-hand side of the library (see
figure 11
).
Figure 11 Removing the
Restraining Bolt
3
Install the library into the rack as shown in
figure 12
and secure the library to the rack
with four Phillips screws.
Note:
If this is a multiple stack configuration, see
Multiple Library Stacks
on page
36 for information on preparing the library chassis for passing tape
cartridges from one unit to another.
Warning:
The Scalar 50 tape library weighs approximately 52 lbs (23.6 kg). At
least two people are required to lift and install the library.
