Fujitsu ETERNUS DX S5 Series, Design Manual

Page: 247 / 335

●
Rear View
Figure 142 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Only One
Controller)
1
2 4 5 6 3
8 8
PSU#0 PSU#1
CM#0
7
1
Controller (CM#0)
(Refer to
"Controllers" (page 257) .)
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
"■ PWC Ports" (page 263) .)
3
Host interface
This interface is used for connecting a controller with a server.
(Refer to
"■ Host Interfaces" (page 259) .)
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
"■ Drive Interface Ports" (page 263) .)
5
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 263) .)
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 263) .)
7
Cover
Remove this when installing an additional controller (optional).
8
Power supply unit (PSU#0, PSU#1)
(Refer to
"■ Power Supply Units" (page 264) .)
6. Hardware Configurations
Controller Enclosure
247 Design Guide