37
3
6
Replace the internal hard disk.
Remove the four blue screws on the back of
the retaining metal bracket, and then remove
the standard-equipped hard disk. Then, use
the blue screws to install the new hard disk.
7
Install the internal hard disk in the PC main
unit.
Install the retaining metal bracket in the
original position by lowering it in the direction
of arrow
1
, sliding it in the direction of arrow
2
, and then sliding it again in the direction of
arrow
3
. Then, secure the retaining metal
bracket with the screw that was removed in
step 5.
8
Connect the cables to the hard disk.
Reconnect the power cord and flat cables that
were disconnected in step 4.
Be sure to connect the flat cables to the
connector with the MASTER marking.
To prevent malfunction, be sure to place the
cables back in their original positions.
9
Attach the upper cover.
10
Use BIOS setup to set the hard disk.
Set the type of the installed hard disk by BIOS
setup (
see "Primary master/slave" in
Section 2, "Main Menu," in Chapter 4, "BIOS
Setup").
2
3
1
08-Chap3(34-44)
25/4/00, 10:36 am
37