9
2
Point
- Before switching on the PC, make sure that display is connected. If the PC is switched on
before the display is connected, the display adapter may not be recognized, and the screen
may not be displayed normally. In this case, connect the display, terminate the OS, switch off
the PC, and then switch on the PC again.
- If the display area is not centered on the screen, adjust the CRT display.
- The power lamp lights up orange when the PC is placed in standby status.
- If POST detects abnormal conditions, an error message is displayed. For error messages,
see Section 1, " Error Messages," in Chapter 5, "Troubleshooting."
- If the CRT display power cord is connected to the PC main unit, the CRT display is switched
on simultaneously with the PC main unit. In this case, the power switch of the CRT display
may remain in the on position, thereby eliminating the need to set the switch at each
operation.
Press the power switch of the PC main unit only when using the PC again, as described in
step 2, at which time the display is switched on automatically.
- Wait about 10 seconds before switching the PC on or off again.
- When starting the screen display or switching the display mode, the screen may become
disordered or vertical lines may appear temporarily (at the start and end screens of Windows
or when returning from the power savings mode).
This is not an error.
- The refresh rate of the screen must be set according to the CRT display to be used. For
extreme overflow or inclination, adjust the CRT display.
After turning on the power, set up the PC.
06-Chap2(8-18)
25/4/00, 10:36 am
9