Fujitsu AOTG30KMTC, Service Manual, Page: 72 / 199

2-21. E: 64. PFC circuit error (Outdoor unit)
Indicator
Indoor unit
Operation indicator 6 time flash
Timer indicator 4 time flash
Economy indicator Continuous flash
Error code E: 64
outdoor unit
Refer to “Error code table (Outdoor unit: for 34 model
only)” on page 1
Detective actuator Outdoor unit
Main PCB
Active filter module
• When inverter input DC voltage is higher than 430
V or lower than 110 V
• If the same operation is repeated 5 times, the
compressor stops permanently.
• When a momentary power cut off occurred on low
voltage
Forecast of cause
External cause
Connector connection failure
Main PCB failure
Active filter module failure
Check point 1. Check external cause at indoor and outdoor (Voltage drop or Noise)
• Instant drop: Check if there is a large load electric apparatus in the same circuit.
• Momentary power failure: Check if there is a defective contact or leak current in the power sup-
ply circuit.
• Noise: Check if there is any equipment causing harmonic wave near electric line. (Neon bulb or
electric equipment that may cause harmonic wave)
Check the complete insulation of grounding.
↓
Check point 2. Check connection of Connector
• Check if connector is removed.
• Check erroneous connection.
• Check if cable is open.
→ Upon correcting the removed connector or mis-wiring, reset the power.
↓
Check point 3. Replace main PCB
If check point 1 to 2 do not improve the symptom, change main PCB.
↓
End
2-21. E: 64. PFC circuit error (Outdoor unit)
- (03-34) -
2. Troubleshooting with error code
TROUBLESHOOTING TROUBLESHOOTING