DryLam
A Trademark of Martin Yale Industries
251 Wedcor Avenue, Wabash, IN 46992
Brian Jennett- Tech-Line & Service Advisor/Manager
Phone: (260-569-7231)
ALM3230 Customer Instruction Manual.docx
Page 63 of 68
Problem
Check if:
Solution
●Laminated sheet is not
discharged. On the
display: DISCHARGE
ERROR or LAMINATION
ERROR,
Laminated paper is stuck in the
lamination section, the trimmer
section and/or the cutter
section.
[1]Open the Feeder cover. Cut the upper and lower film
just below the guide roll. Turn the lamination handle to
OPEN position. Hold the cut film firmly. Pull it out
toward you. Press RESET button. When the laminated
sheet in the machine cannot be taken out, and/or the
problem is not solved, turn off the power and contact
your dealer or the DryLam Tech-Line. [2] Check if the
film waste is stuck in the trimmer unit. [3] Open both
the Trimmer Cover and the Cutter/trimmer Cover.
Remove the film waste. The lamination rollers get very
hot.
Some useful tips.
Flatten and ‘ruffle’ the paper stack before lamination.
If the laminated film has a curl, adjust the film tension
to minimize the curl.
Empty the waste collection box periodically. The
remaining film waste in the waste collection box may
pile up and cause problems around the cutter and
trimmer units.
●”CUTTING ERROR”
Open the dark gray trimmer cover at the rear of the
machine. Raise the Cutter/Trimmer cover (aka: upper
flap). Observe if film/paper has accumulated the area
between the cutter and trimmer units. If so, free it by
pulling it up and out the top of the cover. Close the
cover, press RESET to clear an error on the LCD and
press the Manual Cut Switch. After the film/paper has
been cut pull the waste out from the flap. If the error is
not solved, please contact your dealer or the DryLam
Tech-Line.
●”FEEDING ERROR”
No paper on the tray to feed.
This error is often caused by SET COUNT set to “FREE”
and no paper on the tray. Press RESET to clear the error,
place paper on the tray and try again. To eliminate this
each time the tray runs out go into MODE | SET COUNT
and set this number less than or equal to the number of
sheets placed on the tray.
Paper is thick and smooth on its
surface. The rollers cannot ‘grab’
the paper. Less than 2” of paper
is being pulled before this error
occurs.
Remove the paper. Slightly raise the position of Paper
Feed Resist Roller Pressure Adjust Lever by one slot. See
section
#5-2-12. PAPER FEED RESIST ROLLER PRESSURE
tray. Press RESET button to clear error and start again.
Paper guides on the feeder tray
are restricting the movement of
paper.
Widen Paper Guides slightly by about 1/16” to allow
paper to move freely from the feed tray into the feeder.
Press RESET button to clear error and try again.
