DryLam
A Trademark of Martin Yale Industries
251 Wedcor Avenue, Wabash, IN 46992
Brian Jennett- Tech-Line & Service Advisor/Manager
Phone: (260-569-7231)
ALM3230 Customer Instruction Manual.docx
Page 67 of 68
●TRIMMER DOES NOT
CUT WELL
Check the Feeder Tray.
Adjust the paper guides and/or the feed adjustment
knob (on the feeder tray) so that paper is being inserted
in the center of the film area. This will make the scraps
from the trimmer equal in size for best results.
Waste accumulated in the
trimmer unit
Remove the trimmer unit and check for scrap in, and
around the trimmer unit. Contact DryLam’s Tech-Line
for additional assistance, if needed.
●LEFT AND RIGHT
MARGIN IS NOT EQUAL
Check if the trimmer adjustment
knobs are correctly set.
Adjust the trimmer adjustment knobs.
Is paper skewed within the film
area?
Adjust the skewing knob on the Feed Tray.
●CREASES APPEAR IN
LAMINATED FILM
Tension controller(s) not set
properly?
Run the machine in “Manual Mode” (use the “MOVE”
switch). Run laminated film only out the discharge and
check for wrinkles. Adjust tension controllers as
necessary to minimize wrinkles and curl.
●COMMUNICATION
ERROR
Involves the RFID tag
reader/writer. This error is often
followed by a number:
20: Time out error
01: Invalid command
02: Specified counter error
03: Received data error
04: Data error
05: RFID write error (ch1)
06: RFID write error (ch2, does not apply to the
ALM3230)
Be certain that the RFID tag is in place and directly in
contact with the non-operator side of the frame. See
more about the RFID system elsewhere in this manual.
If the problem occurs frequently, contact your dealer or
the DryLam Tech-Line.
