FujiFilm FinePix FinePix S6500fd, Service Manual

Page: 116 / 138

5-4
5. Inspection
FinePix S6000fd/S6500fd Service Manual
Sequemnce Item Mode Preparations for adjustment
(measurement points, subject, other)
Method of adjustment
(VRs, waveforms, required values)
Measuring
equipment and jigs
Measurement points
(VRs, positions)
8
9
10
Playback check
Playback mode
check
Erase mode check
Playback
Playback
Erase
(1) Plug the AV cable into the
camera.
(2) Check images shot using
the flash (18% gray chart,
shot at a distance of 1 m).
(3) Check images shot at
macro resolutions (manual
photography)
(4) Disconnect the AV cable
from the camera.
Turn the camera off.
(1) Insert a card.
(2) Set the Power lever to
Playback mode.
(3) If a message prompting
the user to set the date
appears, press the button
specified on the right.
(4) Check the playback image.
(1) Select “Erase” -> “Erase
all” from the menu and
then press the “OK” button.
(2) Press the “OK” button
again.
(1) Check that the LCD image
disappears and the
indicator lamp lights green.
(2) Check that the position of
the bright spot is within a
10% circle with a center
that is X = 1% and Y = -3%
from the center of the
vectorscope (see figure
below).
(3) Where the horizontal
resolution is as follows:
350 TV lines or better at
the center and 300 TV
lines or better at the
periphery (NTSC)
300 TV lines or better at
the center and 250 TV
lines or better at the
periphery (PAL)
(3) <DISP/BACK>
(4) Check that the last image
shot appears, regardless
of whether it is automatic
or manual.
Check that the date is
displayed in the
YYYY.MM.DD format.
(1) Check that an erase
message such as the
following appears:
Japan: “
OK?”
Overseas: “ERASE ALL
OK?”
China: “
OK?”
(2) Check that the recorded
images are erased.
Vectorscope
TV monitor
Check that the Y level is 63.4 to 92.2 IRE (NTSC) or 444 to 646 mV (PAL).
Vectorscope center
3%
1%
Check that the bright point
center is within specifications.
10% circle
Fig