FujiFilm BL-7000, Operation Manual

Page: 64 / 78

897N120551D
8-4
Chapter 8 Troubleshooting
Phenomenon Possible cause Countermeasure
The lens cleaning is
insufficient. 1) The tube of the endoscope
is clogged.
2) The air supply pump is
faulty.
1) 2) Straighten the bending section and
then pull out the endoscope slowly.
After removing the endoscope from
the system, according to the VP-7000
Operation Manual, “Chapter 6 Preparation
and Inspection of the System”, make sure
the water and air are discharged from the
nozzle of the distal end. If air and water
are not discharged smoothly, stop using
the equipment and consult your local
FUJIFILM dealer.
Air and water cannot be
supplied. 1) The air supply pump is
“OFF”.
2) The water tank cover is not
closed completely.
3) Too much water in the
water tank.
4) The water tank is empty.
5) It is not connected to the
endoscope firmly.
1) Press the Pump button to set the air
pressure to “HI”, “MID” or “LOW.”
2) Close the cover firmly.
3) Pour in the water up to 80% of the
water tank’s capacity.
4) Pour water into the water tank.
5) Connect the connector firmly.
Suction cannot be
performed. 1) The suction unit is not
operating.
2) The suction tube is bent.
3) The suction tube is
disconnected.
1) Turn “ON” the suction unit.
2) Check if the suction tube is not bent. If
it is bent, straighten the bent part.
3) Connect the suction tube.
Note For details on how to operate the endoscope, refer to the operation manual of the
endoscope.
BL7000_E-50_897N120551D.indb 4 2016/09/05 14:06:19