Fuji Xerox DocuPrint CP405 d, User Manual

Page: 175 / 306

Using the Operator Panel Menus
175
• Port Status
NOTE:
• Port Status feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Values:
• Adobe Protocol
Purpose:
To specify PostScript communication protocol. You can configure the
Adobe Protocol
settings for the wired
network. The change becomes effective after the printer is turned off and then on again.
Values:
System Settings
Use
System Settings
to configure a variety of printer features.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Power Saver Time
Purpose:
To specify the time for transition to power saver mode.
Values:
When you specify 1 minute for
Sleep
, the printer enters power saver mode 1 minute after it finishes a job. This uses
much less energy, but requires more warm-up time for the printer. Specify 1 minute if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operate
with minimum warm-up time. Select a value between 1 and 60 minutes for
Low Power Timer
if you want a
balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the
computer. You can also change the status of the printer to the standby mode by pressing the
( Wake UP ) button
on the operator panel.
Disable Disables the
USB port
.
Enable
*
Enables the
USB port
.
Auto Sets the PostScript communications protocol automatically.
Standard Sets the PostScript communications protocol to
Standard
.
BCP Sets the PostScript communications protocol to
BCP
.
TBCP* Sets the PostScript communications protocol to TBCP .
Binary Sets the PostScript communications protocol to
Binary
.
Low Power
Timer 1min
*
Specifies the time taken by the printer to enter Low Power mode after it finishes a job.
1–60 min
Sleep Timer 1min
*
Specifies the time taken by the printer to enter Sleep mode after it has entered Low
Power mode.
4–6 min