15 Appendix
480
A
p
pe
nd
ix
15
z
When installing the machine in a circumstance using a mail transfer agent (MTA) in
a private segment, set the machine to fit the operation system.
z
For information about supported ISPs, contact our Customer Support Center.
z
When received via POP, the fax cannot be sent using the Fax Gateway feature. This
is because POP receiving does not forward an Internet Fax document received by
e-mail to the fax machine.
Feature Specifications
The following shows the features relating to e-mail.
z
Transmission specifications
Supported protocol
: SMTP
Port number
: 25
Authentication for transmission
SMTP authentication
: supported
POP before SMTP
: Plain and APOP
Waiting time for POP authentication : cannot change
Encryption communication (SSL)
: not supported
z
Receiving specifications
Supported protocol
: POP3
POP3 port number
: 110
Authentication method for POP3
: Plain only (APOP is not supported)
E-mail processing after receiving POP3: delete received e-mail from a server after
receiving. Settings to store e-mail on the
server is not supported.
Encryption communication (SSL)
: not supported
Note
•
IMAP4 is not supported.
IP address settings
The machine does not support a global IP address. Make sure to use the machine
under circumstances using IP masquerade.
z
Operating with fixed address
Register the machine's IP address to a rooter or a server managing IP addresses for
control servers.
z
Operating with DHCP
No settings are needed. Depending on settings of a rooter and a DHCP server,
registration may be needed. Confirm operation rules for the rooter and DHCP server
you use. When access is restricted by MAC address, registration to the DHCP server
may be required.
Settings from the control panel
Before using mail scanning, set the maximum data size for sending e-mail on the
control panel. Refer to the ISP guidelines for the maximum limit. Recommended value
is 1 to 2 MB.
In the System Administration mode, select [Tools] > [System Settings] > [E-Mail/
Internet Fax Service Settings] > [E-Mail Control] > [Maximum Total Data Size] to
perform the setting.
For more information, refer to "Maximum Total Data Size" (P.151).
