Fuji Electric MONITOUCH TS Series, Hardware Specifications, Page: 42 / 115

2
6. LAN Connector (TS1100i/TS1070i Only) 2-25
S
pecific
ations
6. LAN Connector (TS1100i/TS1070i Only)
LAN Connector
This connector is used to connect a controller via Ethernet.
The LAN connector supports 100BASE-TX/10BASE-T.
The LAN connector pins correspond to signals as given below.
Specification: IEEE802.3 (u)-compliant, supporting UDP/IP, TCP/IP, and Auto-MDIX
The LAN connector is associated with LEDs as given below.
Wiring
Use a commercially available cable. Using a self-made cable may cause an error in network
connection.
Recommended cable: 100
Ω
UTP (unshielded twist-pair) cable, category 5, max. 100 m long
* Both straight and cross cables are usable, irrespective of the presence or absence of a hub.
Bottom view
•
TS1100
Bottom view
•
TS1070
LAN Pin No. Signal Contents
1 TX+ Ethernet send signal (+)
2 TX
−
Ethernet send signal (
−
)
3 RX+ Ethernet receive signal (+)
4 NC Not used
5 NC Not used
6 RX
−
Ethernet receive signal (
−
)
7 NC Not used
8 NC Not used
LAN
LED Status
Contents
Green Orange
ON ON Connected via 100 BASE-TX
ON OFF Connected via 10 BASE-T
Blinking ON/OFF Sending/receiving data
8 7 6 5 4 3 2 1
Green LED Orange LED
CAUTION
When using the LAN port, keep the LAN cable away from the power supply cable as
much as possible.