X20/X20S and Ethos v1.2.10 User Manual
7. Turn the transmitter on and then the receiver. If the Green LED on the receiver
is on, and the Red LED is off, the receiver is linked to the transmitter. The
receiver/transmitter module binding will not have to be repeated, unless one of the
two is replaced.
The receiver will only be controlled (without being affected by other transmitters)
by the transmitter it is bound to.
The receiver selected will now show for RX1 the name next to it:
The receiver is now ready for use.
Repeat for Receiver 2 and 3 if applicable.
Refer also to the Telemetry section for a discussion on
Adding a Redundant Receiver
A second receiver may be bound to an unused slot, e.g. either RX2 or RX3 to
provide redundancy in case of reception problems. Either a 2.4G or 900M
receiver may be the backup for redundancy. Our example below shows a 900M
receiver being added.
1. Connect the SBUS Out port of the redundant receiver to the SBUS IN port of
the main receiver.
2. Power up the receivers (the redundant receiver can be powered via the SBUS
cable.
3. Register the new receiver.
86
rev 3
Summary of Contents for TANDEM X20
Page 1: ...X20 and Ethos User Manual...
