X20/X20S and Ethos v1.2.10 User Manual
Type: TD MODE
ACCESS and TD MODE change the way receivers are bound and connected with the
transmitter. The process is broken into two phases. The first phase is registering the
receiver to the radio or radios it is to be used with. Registration only needs to be
performed once between each receiver / transmitter pair. Once registered, a receiver can
be bound and re-bound wirelessly with any of the radios it is registered with, without
using the bind button on the receiver.
Having selected the TD MODE, the following parameters must be set up:
2.4G
The 2.4G RF module is already enabled.
Select Internal or External (on ANT1 connector) Antenna. Although the RF stage has
built-in protection, it is good practice to ensure that an external antenna has been
fitted before selecting the External antenna. Please note that the antenna selection is
on a per model basis, so each time a model change selection is made ETHOS sets the
antenna mode for the given model.
900M
The 900M RF module is already enabled.
Antenna
: Select Internal or External (on ANT2 connector) Antenna. Although the
RF stage has built-in protection, it is good practice to ensure that an external
antenna has been fitted before selecting the External antenna. Please note that the
antenna selection is on a per model basis, so each time a model change selection is
made ETHOS sets the antenna mode for the given model.
Power
: Select the RF Power desired between 10, 25, 100, 200, 500mW, 1000mW
In TD MODE mode the 2.4g and 900m RF paths work in tandem with one set of
ACCESS controls. There can be three Tandem receivers registered.
96
rev 3
Summary of Contents for TANDEM X20
Page 1: ...X20 and Ethos User Manual...
