8
INSTALL FRONT SUPPORT ARMS
(
FAJK003
)
PREP FOR RACK INSTALL
(
FAJK005
)
Clean the area around all the 22mm
holes drilled in the roof with
methylated spirits/denatured alcohol.
Insert the Aluminum Spacer (Item 6)
into the Foam Washer (Item 5) and
remove paper the backing from the
Foam Washer to expose the adhesive.
Insert the washer/spacer
combination, adhesive side down, into
the 22mm holes so that the spacer
comes to rest on the Rear Support
Brackets underneath.
Firmly press the Foam Washer all the
way around securing it to the roof.
Clean the area around all the 22mm
holes drilled in the roof with
methylated spirits/denatured alcohol.
Insert the Aluminum Spacer (Item 6)
into the Foam Washer (Item 5) and
remove paper the backing from the
Foam Washer to expose the adhesive.
Insert the washer/spacer
combination, adhesive side down, into
the 22mm holes so that the spacer
comes to rest on the Rear Support
Brackets underneath.
Firmly press the Foam Washer all the
way around securing it to the roof.
Grab your T40 Torx Wrench and remove the six bolts holding the Window Corner Plate in place. Be careful
not to let the plate fall when removing the last bolt as this may result in damage to the paintwork of the
part or your vehicle.
Remove the paper backing form the Rubber Strips supplied and apply five pieces to the inside of each
Front Support Arm as indicated below. The strips are applied to avoid damaging the vehicle's paintwork.
Fasten the Front Support Arms (Item 17) over the Window Corner Plates using the original bolts.
(
)
A
REV_B03
120mm
XML Shape(7)
(
)
A