4
Using the T40 Torx Wrench, remove the two Torx Bolts, either side of
the front seat headrests, holding the rear roof to the vehicle body.
Grab a friend to help you lift the roof off and place it on a blanket or
suitable work surface on the ground as not to damage it.
REMOVE AND DRILL ROOF...CONT.
(
)
FAJK002
(
)
C
REV_B02
Measure 130mm to
centre of hole from
rear edge of roof.
Measure 130mm to
centre of hole from
rear edge of roof.
Place the left and right Tray Support Brackets (Item 13) in position on the corresponding outer ribs as
shown below. Mark the position of the four "feet" using a suitable marker. Remove the brackets. Using
masking tape, tape the marked area on the roof where the four "feet" sat. (This is done to help protect
your vehicle's roof when drilling in Step 2E.)
Place the brackets back in position, making sure to line up the shape of the brackets to the shape of the
roof.
Using a measuring tape, adjust the brackets so that the centre of the two holes, as indicated by the
arrows, are 130mm in from the rear edge of the roof and in the centre of the roof rib. Ensure that the other
three inside holes are also in the centre of the roof rib. Take a suitable marking pen and mark the position
of all the holes onto the roof.
Remove the brackets and check that the inner row of holes are running in a straight line down middle of
the rib. If they do not look straight, stop and re-mark before you start drilling. Remember measure twice,
drill once.
(
)
d