7
PREP FOR RACK INSTALL
(
FAJK005
)
Clean the area around all the 22mm
holes drilled in the roof with
methylated spirits/denatured alcohol.
Insert the Aluminum Spacer (Item 6)
into the Foam Washer (Item 5) and
remove paper the backing from the
Foam Washer to expose the adhesive.
Insert the washer/spacer
combination, adhesive side down,
into the 22mm holes so that the
spacer comes to rest on the Rear
Support Brackets underneath.
Firmly press the Foam Washer all the
way around securing it to the roof.
Clean the area around all the 22mm
holes drilled in the roof with
methylated spirits/denatured alcohol.
Insert the Aluminum Spacer (Item 6)
into the Foam Washer (Item 5) and
remove paper the backing from the
Foam Washer to expose the adhesive.
Insert the washer/spacer
combination, adhesive side down,
into the 22mm holes so that the
spacer comes to rest on the Rear
Support Brackets underneath.
Firmly press the Foam Washer all the
way around securing it to the roof.
REV_B02
If not already assembled, assemble your Tray as per the Universal Tray Assembly Instructions (Document
RRSTUNI)
(
)
B
(
C
)
After fitting the Wind Deflectors, the Tray should still be upside down, loosely mount the Tray Support
Brackets (from FAJK004 box) to the Tray using Items 10, 11 & 12. As before use the machined slots to
insert the Hex Bolts into the Slats.
The rear of the Tray Support Bracket must mount onto the very last Slat (Combined Slat) and
approximately 80mm in from the outer edge of the side of the Tray. Do not tighten the bolts yet.
You're almost finished. Take a quick breather before mounting your Tray to your Jeep.
(
)
A