10
MOUNT YOUR TRAY
With the help of a friend, flip the Tray end over end so that it is in the upright position. (The Tray is
flipped end over end so that bolts and brackets do not slide left and right).
With one of you on either side of the Tray, lift the Tray and walk it into position above the vehicle,
approaching from either the front or rear of the vehicle.
Line up the Front Support Arms with the two Hex Bolts either side of the Wind Deflector and hand
tighten the front of the Tray to the arms using Items 15&16 (from FAJK003 box).
The Rear Tray Support Brackets should still be loose enough to move around. Line the brackets up
with the holes on the roof and fasten them into position using Items 3, 4, 7 & 8 (from FAJK005 box).
Centre the Tray from left to right. Use a tape measure to double check. Once you are happy that the
Tray is in the correct position, fasten all nuts and bolts securely both inside and outside of the
vehicle on all brackets that were installed.
Push the Plastic Nut Caps (Item 9 from FAJK005 box) provided over all the exposed bolts and to
close up all the roll bar padding.
Take a step back and admire your work. Good job!
(
)
A
REV_B03