7
PREP AND INSTALL REAR SUPPORT ARMS...CONT.
Place the Rear Support Brackets back over the the roll bars
lining them up with your marking from Step 3C.
Using the M6 Nyloc Nuts and Flat Washers supplied (Items 3
& 4), loosely fasten the brackets to the roll bars.
Grab the two Rear Support Brackets (Items 1 & 2 from
FAJK005 box). Line up the left and right brackets (Refer to
block below) with the corresponding holes in the roof. With
your black maker, mark the position of where the Rear
Mounting Brackets need to bolt onto the roll bar.
With the help of a friend, remove the roof.
Using a suitable piece of wood, steel or other object,
rest it across the centre of the two Rear Support
Brackets. Adjust the two brackets by rotating them
inwards or outwards so that they are both sitting
horizontal/straight. Use the plank or chosen object as
a reference guide. Once happy, hand tighten the back
four nuts (two top and two bottom).
With your friend, place the roof
back onto the vehicle, and
re-fasten the bolts.
Use the two holes and ribs as indicated to identify
between the left and right brackets. The two holes
must be towards the rear of the vehicle and the
ribs must be on the INSIDE of the roll bar.
(
C
)
(
)
D
(
)
E
(
F
)
REV_B03