Fronius TransSteel 3500 Rob, Operating Instructions Manual

Page: 52 / 104

52
MIG/MAG welding
Safety
General tasks be-
fore MIG/MAG
welding Only where cooling units and a water-cooled welding torch are used:
Connect the water hoses of the welding torch to the correct plug-type connectors on
the wire-feed unit
Plug in the mains plug
Move the mains switch to the "I" position:
- all the indicators on the control panel light up briefly
- where applicable, the cooling unit starts to run
IMPORTANT! Follow the safety rules and note operating conditions in the cooling unit op-
erating instructions.
Overview MIG/MAG welding is composed of the following sections:
-
MIG/MAG standard synergic welding
- MIG/MAG standard manual welding
- Special functions and options
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
-
these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! An electric shock can be fatal. If the power source is connected to the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Before carrying out any work on the device make sure that:
-
the power source mains switch is in the "O" position
- the power source is unplugged from the mains
1
2
3