Fronius TransSteel 3500 Rob, Operating Instructions Manual

Page: 30 / 104

30
No. Function
(1) "Parameter selection" button (right)
a) for selecting the following welding parameters
Arc length correction
for correcting the arc length
Welding voltage in V *)
Before the start of welding, the system automatically displays a standard val-
ue based on the programmed parameters. During welding, the actual value is
displayed.
Dynamic
for influencing the short-circuiting dynamic at the moment of droplet transfer
- ... harder, more stable arc
0 ... neutral arc
+ ... soft, low-spatter arc
Real Energy Input
for displaying the energy applied during the welding operation. **)
b) for changing parameters in the Setup menu
(2) "Parameter selection" button (left)
a) for selecting the following welding parameters
Sheet thickness
Sheet thickness in mm or in.
If the welding current to be selected is not known it is sufficient to enter the
sheet thickness. The required welding current and any other parameters
marked with *) will then be adjusted automatically.
Welding current *)
Welding current in A
Before the start of welding, the device automatically displays a standard value
based on the programmed parameters. During welding, the actual value is
displayed.
Wire feed speed
*)
Wire feed speed in m/min or ipm.
b) for changing parameters in the Setup menu
(3) Adjusting dial (right)
for changing the arc length correction, welding voltage and arc-force dynamic pa-
rameters
for changing welding parameters in the setup menu
(4) Adjusting dial (left)
for changing the sheet thickness, welding current and wire feed speed parameters
for selecting welding parameters in the Setup menu
(5) "Save" buttons (Easy Job)
for saving up to 5 operating points