Fronius TPS/i Push, Operating Instructions Manual

Page: 125 / 152

Special care of O-
rings IMPORTANT! When replacing O-rings, grease the new O-ring before fitting it.
When repeatedly connecting and disconnecting the coolant hoses on the torch hosep-
ack, grease the O-rings regularly.
Unless a special grease is specified for the O-rings, use the O-ring grease from Fronius
with item number 40,0009,0044.
Whenever the
welding torch or
torch hosepack is
changed Whenever the welding torch or torch hosepack is changed, ensure that the coupling
point is clean and dry. Remove any coolant that has escaped from the coupling point.
Every 6 months
CAUTION!
Danger of damage to electronic components.
▶
Do not bring the air nozzle too close to electronic components.
- Open covers, remove device side panels and clean inside of device with dry
reduced compressed air. After cleaning, restore device to its original state.
Preparing the WF
15i/25i/30i R PAP
for replacement
of the welding
torch inner liner
1 2
WARNING!
Toppling or falling devices can cause life-threatening injuries.
Robot movements may not take place until:
▶
The wirefeeder has been retracted and locked
▶
All cables, leads and hosepacks are securely connected to the wirefeeder
125
EN