Fronius Robacta Reamer X-Line J, Operating Instructions Manual

Page: 41 / 76

Starting up the fill-level control sensor
General The fill-level control sensor releases a signal as soon as the fill level in the parting agent
container falls below a defined level.
Operating con-
trols and displays
on the sensor
(1)
(2)
(3)
(1) ‘OUT OFF’ key
to program the sensor
(2) ‘OUT ON’ key
to program the sensor
(3) LED
shows the operating mode of the
sensor
-
LED on/flashing: Sensor act-
ive
- LED off/ not flashing: Sensor
inactive
Performing
empty adjust-
ment
20 mm (0.79 in.)
1
Drain the parting agent container until
the parting agent is at least 20 mm
(0.787 in.) below the sensor
2
Connect the sensor to the power sup-
ply
2 - 6 s
3
Hold the ‘OUT OFF’ key for at least 2
seconds, maximum 6 seconds
-
The LED on the sensor flashes
slowly
- after releasing the ‘OUT OFF’ key,
the LED turns off once again - the
sensor has detected a low fluid
level
41
EN-US